Compared with drum brakes, the SP series pneumatic failure protection brake has the advantages of compact structure, large braking force, and easy installation. It is mainly used for mechanical braking or deceleration in various industries such as lifting, transportation, metallurgy, mining, ports, construction machinery, cables, suspension equipment, wind turbines, textile machinery, etc
Usage conditions:
Environmental temperature: -20 ℃ -50 ℃.
There should be no flammable or explosive gases in the surrounding working environmentThe relative humidity of the air shall not exceed 90%The altitude of the usage site complies with GB755-2000Outdoor rain and snow erosion or corrosive gases and media should use anti-corrosion (based on actual reports) products
SP series pneumatic failure protection brake product details
Working brake, allowing high-frequency braking.
High braking force, low maintenance cost, equipped with automatic compensation device for pad wear (stable braking torque), and short response timeLarge installation tolerance, brake disc end face runout: larger value: ± 0.2mm. The verticality deviation of the base relative to the disc: larger value: ± 4 ‰The center distance deviation of the brake disc relative to the base: larger value: ± 2.5mmThis series includes the following types of brakes: 561SE, 560SE, 56SE, 5SE, 450SE, 4SE, and 3SE brakes (electromagnetic release). An ESE/ESP matching power supply is required during work5SH, 450SH, 4SH, 3SH, 904SH brakes (hydraulic release). A hydraulic station is required for work
5SP, 450SP, 4SP, 3SP brakes (pneumatic release) (5bar)
This series includes the following types of brakes:
All SE series.
. Electromagnetic release. When working, there must be a matching power supply ESE/ESP (specific parameters can be found in the matching power supply)All SH series are mainly ST series. Hydraulic release. Equipped with a hydraulic station during operationAll SP series. Pneumatic release (5 bar)
Note: ST1SE and ST2SE are only suitable for use as safety brakes. It can also be used as a working brake when the frequency of use is very low
According to the different needs of users, the following devices can be installed:
Pad wear display (achieved by displaying the wear line in the switch or pad)
Brake display (achieved through display switch)
Manual release display (achieved through display switch)
Special application: Used for sintered pads when the disc temperature is very high, special pads (without sparks, etc.); Special plate (thickness, diameter, material, etc.)
If you have any requirements, please contact our technical personnel
Spring brake - Pneumatic release - Suitable for disc thickness: 15 or 30mm
